User's Manual

-3-
↓
Power
Jack↓
Product Overview and Accessories
Unpacking and Setting Up
Unpack the carton, remove all protective material
and take the printer out of the package.
●Power On the Printer
●Side View
●Back View
■Side View
■Back View
●Front View
Connect power adapter, power cord to the printer.
Switch on the printer.
Shake the resin bottle for about 10 seconds.
Assemble the nozzle cap and the inner tube, and
replace the original bottle cap with the assembled
one.
Put the bottle into the bottle slot. Install the filling
tubes (First, attach the black tube to the thick
nozzle. Then attach the transparent tube to the thin
nozzle and push all tubes down.)
●Raise the Platform
●Install the Resin Bottle
●Refill Resin
Select "UTILITIES" > "MOVE PLATFORM" > "TO
TOP" > "YES" to raise the platform.
Remove the protective materials under the platform.
※Keep original packaging material in the event of
sending your unit back for repair.
Power
Switch
↓
←Platform
↑
Resin Tank
LCM→
←Operation
Panel
USB Disk
Port→
Filling Tube→
The Nobel Superfine is shipped with the below parts and accessories. After unpacking, please
check if there is any damage on the printer and accessories. Please contact customer support
for any missing or defective parts and accessories.
■USB Cable
■USB Flash Disk
■
Rinse Basket
■Scraper
■Gloves
■
Starter
Resin
■Nozzle Cap
■Inner Tube
■
Power Cord
■ Power Adapter
Resin Bottle
Slot→
■ Quick Start Guide ■ Warranty Card
Up
Refill the resin tank before sending the printing task.
Please select "UTILITIES">"REFILL RESIN" on the
printer screen. And press and hold the UP key to
infuse resin into the tank. Release the UP key until
the resin reaching the "Max" mark on the resin
tank(The resin capacity to MAX mark on the resin
tank is about 90g), to avoid resin effluence from the
resin tank.
Note
Before changing the resin bottle, remove the
transparent tube first, then remove the black tube.
Thick hole
Thin hole
USB
Cable
Port