User's Manual

-5-
LCM Menus
REFILL RESIN
The "Utilities" menu gives the user control over the printer settings. Users can choose to refill resin manually, and move the Z-axis when necessary.
Select "REFILL RESIN" and press "OK". Press and hold the UP key to infuse resin into the tank.
Release the UP key until the resin reaching the "Max" mark.
If you want to refill resin during printing, press "OK" to launch "ACTIVE MENU" page and select "REFILL RESIN". To refill resin, follow the same operations.
The "Settings" menu alows you to adjust printer settings.
To pause printing
To cancel printing
To refill resin
MOVE PLATFORM
Activate the function when you need to move the platform manually.
Simply select move the platform “to top” or “to bottom” to proceed:
WIFI is disabled by default. To enable WIFI connection, follow the steps below:
UTILITIES
WIFI
SETTINGS
Up
Connect to a new WiFi connection. Current WiFi connection, if any, will be disconnected after this option is selected.
Cancel setting and go back to "SETTING" menu.
Disconnect current WIFI connection.
Select WIFI and enter WIFI setting.
The printer will start to looking for available WIFI after selecting "CONNECT NEW".