Operation Manual
Table Of Contents
- INTRODUCTION
- DISCLAIMER
- SAFETY AND COMPLIANCE
- 1. UNPACKING AND INSTALLATIONS
- 2. PRODUCT OVERVIEW
- 3. OPERATING THE PRINTER
- PRINT MENU
- RESIN MENU
- SETTINGS MENU
- Structure of the SETTINGS menu
- Platform
- General
- Adjusting the audio volume
- Changing the display language
- Structure of the Wireless icon
- Connecting to a Wi-Fi network
- Connecting to a hidden Wi-Fi network
- Structure of the Ethernet icon
- Enabling Ethernet connection
- Manually configuring Ethernet network
- Viewing the IP address
- PRINTING CONTROLS
- 4. OPERATING XYZprint AMUV
- SOFTWARE INTERFACE
- KEYBOARD SHORTCUTS AND MOUSE CONTROLS
- CONNECTING TO THE PRINTER
- COLOR DISPLAY OF OBJECTS
- PREFERENCE SETTINGS
- PREPARING THE FILES
- MANIPULATING MODELS ON THE WORKSPACE
- CONVERTING TO THE PRODUCTION FILES
- SAVING MODELS ON THE WORKSPACE
- SWITCHING THE VIEW OF THE WORKSPACE
- VIEWING THE INFORMATION OF THE MODELS
- SYSTEM VERSION AND UPDATE
Version 1.0
PartPro120 xP Operation Manual
5. Click “Generate” after setting up all marks.
6. Adjust the contact area of the branches if necessary.
To adjust the contact area of the branches, go back to the function menu “Support” > “Tree”, and select the
button “Contact Area”.
Click on the targeted branch (selected branch will change to blue) and drag the slider to adjust the contact
area.
Click “Done” once you have adjusted the contact area of all cones.
When no trunk is selected, the branches will be shown as yellow marks. Simply click on a trunk, the
branch marks will be connected to the selected trunk.
Branch mark should be higher than the top of the selected trunk.
Branch setting is disabled when no trunk is added. Please set up trunks before adding branches.
Branches over 45 degree slope will be shown in red, as they may be displaced in the printing process.
CONVERTING TO THE PRODUCTION FILES
Exporting the files
When finishing editing the files and the supports, click on [Export] to save the model to a sliced .3wn file. Once
the file is sliced, you may skip repeating settings in the future.
To export the file:
1. Click [Export] icon.
2. Setup below settings based on the printing quality
required and the resin material will be used, and click
[Export] to slice the file.
Layout Will Be Changed
Function Remain The Same
Layout Will Be Changed
Function Remain The Same
37