Security Datasheet

ManualsBrandsXYZprinting Manuals3D Printer FilamentsFilament PLA 1.75 mm 600 g Green 1 pc(s)

Material Safety Data Sheet

Product Name: PLA Filament

1. COMPANY IDENTIFICATION

Company: XYZprinting, Inc.

Address: No.147, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City, Taiwan (R.O.C.)

Information Phone No.: 886-2-7705 8001

Emergency Phone No.: 886-2-7705 8001

2. HAZARD IDENTIFICATION

Classification: This product is NOT classified according to European Union (EU) Regulation

EC No.1272/2008

Hazard Statement: None

Precautionary Statement: None

Signal Word: None

Pictogram: None

Potential Health Effects: See Section 11 for more information

Environmental Precautions: See Section 12 for more information.

Other Hazards: If small particles are generated during further processing, handling, or by

other means, combustible dust concentrations in air may form. See Section 7 and 8 for

additional information.

3. COMPOSITION/INFORMATION ON INGREDIENTS

Substance Identity

CAS No.

Approx. Weight (%)

Polylactide resin

9051-89-2

0-90%

Impact modifier

Trade secret

0-10%

4. FIRST AID MEASURES

Eye Contact: Rinse immediately with plenty of water, also under the eyelids, for at least 15

minutes. Call a physician immediately.

Skin Contact: Adverse effects are not expected from accidental skin contact following

occupational exposure. After contact with skin, wash immediately with plenty of water.

If skin irritation persists, call a physician. Cool skin rapidly with cold water after contact with hot

polymer. DO NOT attempt to remove hot polymer from skin or contaminated clothing as skin

may be easily damaged. Call a physician immediately.

Summary of content (5 pages)

PAGE 1
Material Safety Data Sheet Product Name: PLA Filament 1. COMPANY IDENTIFICATION Company: XYZprinting, Inc. Address: No.147, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City, Taiwan (R.O.C.) Information Phone No.: 886-2-7705 8001 Emergency Phone No.: 886-2-7705 8001 2. HAZARD IDENTIFICATION Classification: This product is NOT classified according to European Union (EU) Regulation EC No.
PAGE 2
Inhalation: Move to fresh air. Call a physician immediately. Ingestion: Drink water as a precaution. Never give anything by mouth to an unconscious person. Do not induce vomiting without medical advice. Call a physician immediately. Notes to physician: Treat symptomatically. 5. FIRE-FIGHTING MEASURES Suitable Extinguishing Media: Foam, Water, Carbon dioxide (CO2), Dry chemical, Alcohol resistant foams are preferred if available.
PAGE 3
Storage: Store at temperatures not exceeding 122°F/ 50°C. Keep cool. No special restrictions on storage with other products. Precautions: No special precautions required. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Engineering Measures: Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. Provide appropriate exhaust ventilation at places where dust is formed. Personal Protective Equipment: a. Eye: Safety glasses with side-shields. b.
PAGE 4
10. STABILITY AND REACTIVITY Reactivity: None expected under conditions of normal use. Chemical Stability: Stable under recommended storage conditions. Conditions to Avoid: Temperatures above 446°F (230 °C). Avoid keeping resin molten for excessive periods of time at elevated temperatures. Prolonged exposure will cause polymer degradation.
PAGE 5
2. The container for this product can present explosion or fire hazards, even when emptied. To avoid risk of injury, do not cut, puncture, or weld on or near this container. Since the emptied containers retain product residue, follow label warnings even after container is emptied. 14.