Operation Manual

22
soFtwAre
This screen informs you about installed Software versions.
Navigation SW is only available at model X-302BT.
Operation buttons Setup Software
1. Source Tap to enter Main Menu
2. Clock Time Shows Clock time
3. General Tap to enter general mode
4. Safety Tap to enter safety mode
5. Display Tap to enter display mode
6. Audio Tap to enter audio mode,
7. Software Tap to enter software mode, if not already active
8. Misc Tap to enter misc mode
Information fields
9. Version Text Shows detailed software version information
23
setup Misc
Operation buttons Setup Misc
1. Source Tap to enter Main Menu
2. Clock Time Shows Clock time
3. TFT Standby Tap to start TFT standby function
4. BT mic gain Tap to change microphone input gain
5. BT name order Tap to change the display sort order of the phonebook
6. Tuner Profile Tap to change tuner mode (stereo > mono)
7. Monitor Tap to change value of monitor (AUTO > SHOW > MANUALLY)*, only
for X-101BT.
8. View Angle Tap to set monitor tilt angle (only for X-101BT)
9. General Tap to enter general mode
10. Safety Tap to enter safety mode
11. Display Tap to enter display mode
12. Audio Tap to enter audio mode
13. Software Tap to enter software mode
14. Misc Tap to enter misc mode, if not already active
15. Clock If no other setting is changed (3 ~8) you can tap the clock to set it manually*
*Note: angle adjustment X-101BT
This setting will define the behaviour of the retractable monitor.
*Note: setting the clock
XZENT has an integrated clock that will be automatically synchronized by RDS time signal. Sync is
performed only once on each device start and may require several minutes to show correct real time,
depending on the FM signal quality of the radio station you are listening to. The X-302BT uses a soft-
ware clock which is synchronized by GPS signal. The GPS sync’d time is used for route calculation.
Power on Power off
Auto Slide out Slide in
Show Slide out Stay extended
Manually Stays retracted Slide in
3 4 5 76 8
9
10 11 1312 14
9
1 2 1 2
6
7
8
3
5
4
15