User's Manual
Table Of Contents
- WHLIP229_FCCID_UserManual.pdf
- FCC Warning.pdf
- _
- FCC Warning
- _
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- _
- NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- _
- This device must be installed to provide a separation distance of at least 20 cm from all persons
- and must not be collocated or operating in conjunction with any other antenna or transmitter.
- _
- _
- _
9
Camera Setup Installation & Usage
The camera Setup utility can easily and quickly detect cameras connected to your local network and list them
on the Camera Setup window, also you can use the camera Setup utility to assign an IP address to each
camera.
1. Insert the Installation CD into your CD-ROM drive and the installation screen should appear automatically
(See image below). If it does not, click “Start” then “Run”. In the text field enter “D:\autorun.exe” (if “D:” is the
letter of your CD-ROM Drive)
2. Click on “Install Camera Setup” and the following screen will be displayed.
3. If you want to change the default folder click “Change” to replace otherwise click “Next”