Use and Care Manual

13 | P a g e
7. With rod removed loosen the bracket which holds the motor in place.
8. The motor has a wire attached to the motherboard.
9. Undo the plastic ties which hold the wires in place. Remove the motor wire which is
attached to the motherboard.
10. Place new motor into correct position and attach the wire to the motherboard.
11. Once motor is in correct position reattach motor to the bracket.
12. Reattach the bracket to the side of the firebox.
13. Reattach rod to bracket
14. Reattach bracket to the firebox.
15. Place brown plastic backing back into correct position and screw in fasteners to secure.
16. Secure black trimmings on the inside of the firebox.
17. Slide glass back into place.
18. Tighten fasteners and cover back into position. The rod replacement process is complete.