Use and Care Manual

6 | P a g e
4. Remove the black trimming from the inside of the firebox.
5. Remove screws and then slide out the glowing embers .
6. The rod is secured by a pin along with a bracket on either side of the firebox. Loosen the
bracket that doesn’t contain the motor by unscrewing the fasteners.
7. Detach the pin from the unit.
8. Remove rod.
9. With new rod measure to the correct dimension, cut and place where original rod was
located.
10. Place brown plastic backing back into correct position and screw in fasteners to secure.
11. Secure black trimmings back into place.
12. Slide glass back into place.
13. Tighten fasteners and cover back into position. The rod replacement process is complete.