Instructions / Assembly

Remote Control
DIMMER ON/OFF
HIGH
A Infrared Window
B On/Off Switch
C Flame Effect Dimmer
D Heater Maximum Heat
E Heater Low Heat
1.
Prior to use, the remote control handset requires i nstallation of
batteries (Figure 8 ).
2.
Remove the cover on the rear of the remote
batteries as shown and then slide the cover back in to the original position.
3.
To enable the remote control to function the power t o the fire
4. At
a distance of 5 to 6 feet, point the remote control directly towards the bottom right
hand side of the fire
place
B On/Off Switch
Press on/off switch to turn fire on.
C Flame Effect Dimmer
To operate press once to commence dimming cycle. D
dimming cycle the fire will slowly dim then brighten allowing user to choose suitable
level. Press a second time to stop cycle when the desired brightness level is obtained.
Failure to press dimmer a second time will result in the fire dimming
repeatedly.
HIGH
\LO W
Prior to use, the remote control handset requires i nstallation of
the two included
Remove the cover on the rear of the remote
control
by sliding backwards. Install the
batteries as shown and then slide the cover back in to the original position.
To enable the remote control to function the power t o the fire
place
must be switched on.
a distance of 5 to 6 feet, point the remote control directly towards the bottom right
place
. (Figure 9 )
Press on/off switch to turn fire on.
To operate press once to commence dimming cycle. D
dimming cycle the fire will slowly dim then brighten allowing user to choose suitable
level. Press a second time to stop cycle when the desired brightness level is obtained.
Failure to press dimmer a second time will result in the fire dimming
then brightening
12 |
P a g e
the two included
AAA
by sliding backwards. Install the
batteries as shown and then slide the cover back in to the original position.
must be switched on.
a distance of 5 to 6 feet, point the remote control directly towards the bottom right
To operate press once to commence dimming cycle. D
uring the
dimming cycle the fire will slowly dim then brighten allowing user to choose suitable
level. Press a second time to stop cycle when the desired brightness level is obtained.
then brightening