User's Manual

10 TERMINAL PROFESSIONAL INSTALLATION AND ADMINISTRATION GUIDE
4 Installing the terminal
Step 1. Complete the Before-You-Begin checklist
Before you begin installing the terminal, complete this checklist:
If possible, register and acquire access to the Y Soft online help desk a day or two before you begin
the installation. (See page 7.)
Obtain the Terminal Professional installation packages (see page 11) and a small Phillips
screwdriver.
Make sure YSoft SafeQ Server is installed and running.
Write down the terminal’s serial number (located on the back of the terminal).
Make sure the Control Interface cable (see page 11) is the correct cable for the MFP you are
connecting the terminal to.
NOTE: Refer to the MFP/cable part number compatibility list that Y Soft provided you or go
to http://helpdesk.ysoft.com and check the list there.
If the cable you have is not correct, find the correct cable before you proceed. The
cable may be among other Y Soft packages at the location where you are installing
the terminal.
Obtain the following information:
SafeQ server IP address _______________________________________________________
Does the network support DHCP? Yes____ No____
If it does not support DHCP, obtain this additional information:
Terminal IP address __________________________________________________________
Netmask address ____________________________________________________________
Gateway IP address __________________________________________________________
DNS server IP address ________________________________________________________
Information about the MFP or printer:
IP address _________________________________________________________________
Serial number ______________________________________________________________
Model number _____________________________________________________________