User's Manual

4.9.2009

YSOFT SAFEQ TERMINAL ULTRALIGHT  ADMINISTRATORS GUIDE V1.5 [EN] 10/19

Picture 6 - Interface of Terminal UltraLight – Print Only

WARNING

Use the original power supply received with the Terminal UltraLight only! Another power supply may

damage the terminal. Such damage would not be covered by the warranty.

 SAFETY NOTICE

The Terminal UltraLight is not equipped with any power switch. Therefore the power socket MUST

be on visible and available place during the time the Terminal is on.

3.2 TERMINAL MOUNTING

The exact use of installation kits (received with the terminal) depends on the specific set and model of your

device/MFD.

Mounting kit may be fixed to the terminal by unscrewing one of the screws in the back, fixing the metal

piece(s) and replacing the screw(s). In some cases, a dual-sided adhesive tape should be used to prevent the

terminal from wobbling.

3.3 TERMINAL CONFIGURATION

There is special tool for configuration of Terminal UltraLight  SafeQ Terminal Configuration utils  see Picture