User's Manual

4.9.2009
YSOFT SAFEQ TERMINAL ULTRALIGHT  ADMINISTRATORS GUIDE V1.5 [EN] 14/19
5 TERMINAL BEEP AND FLASH CODE SEQUENCES
The Terminal UltraLight contains status leds that serve for interaction with user. This chapter provides list of
beep and flash code sequences as well as their meanings.
5.1 TERMINAL ULTRALIGHT BEEP CODE SEQUENCES
In the -
- Card read error. Please try placing the card again or use the different card.
.- Terminal validation failed. Server reports that the terminal is not registered on SafeQ. Please consult
administrator manual.
-- No print job waiting in queue.
..- User quota has exceeded.
-.- User validation failed. User entered either invalid pin or user card is not registered in the system.
.-- Received error or warning message from server.
--- Connection to SafeQ server failed.
...- Hardware configuration damaged, cannot continue in booting.
-..- Maximum number of update attempts reached but no valid firmware detected.
.-.- Update of firmware failed.
--.- Software configuration cannot be saved. Probably faulty onboard eeprom.
..-- Software configuration damaged, loading defaults.
-.-- Maximum number of update attempts reached, resuming normal boot.
.--- Firmware damaged.
---- Network init failed.
.... Keyboard PCB failure.
-... No reader connected and reader required for correct functionality.
.-.. Update of firmware failed. Error in server response, SafeQ server is probably not configured correctly.
--.. Update of firmware failed. Cannot connect to SafeQ server.
-...- Debug mode, not for public release!
5.2 TERMINAL ULTRALIGHT FLASH CODE SEQUENCES
This section provides flash code sequences used for interaction with a user.
There are following colors used for icons: