User's Manual
4.9.2009
YSOFT SAFEQ TERMINAL ULTRALIGHT ADMINISTRATORS GUIDE V1.5 [EN] 8/19
The keyboard requires calibration for proper operation. The calibration is done each time the Ter-
minal UltraLight is started. It is therefore absolutely necessary not to touch the keyboard during
terminal startup otherwise the keyboard may not work properly.
It may happen that the keyboard will become less or much more sensitive to touches after a long pe-
riod of operating time or when electrostatic or electromagnetic properties in the surrounding area
change. When this problem occurs it is necessary to reboot or power off/power on the terminal so it
would automatically calibrate the keyboard to new environment values.
2.3 TERMINAL ULTRALIGHT SPECIFICATION
Parameter
Value
Control
Capacitive keyboard
Identification
Using a card reader or PIN or any combination
Network
2-port 10/100 Mbit switch (auto MDI/MDIX)
Processor
Freescale Coldfire v2
Memory
64kB RAM, 512kB Flash
Terminal el. power supply input
12V DC
Maximum current input
1.0A
Working temperature
+535
Storage temperature
Working air humidity
20% to 85% without condensation
Storage air humidity
8% to 85% without condensation
Resistance to magnetic field
no added resistance