Operation Manual

17
Delete the registered DP-ID
1 Touch
[
SETUP
]
or
[
B SETUP
]
to display the frequency set up screen, then touch
[
F
]
on the bottom of the
screen.
2 Touch
[
ID MODE
]
to select the “DP-ID”.
Touching
[
ID MODE
]
switches the setting as follows:
à “DP-ID” à “DG-ID” à “DP-ID” à
The DP-ID display returns to the DG-ID display in about 5 seconds.
3 Keep touching
[
ID MODE
]
(DP-ID) for more than two seconds.
The DP-ID list screen appears.
SETUP Ver.1.xxx EXP A1






U
P
N
KI
L
N
KI
L






DO
WN
F
M/V SQL
Tx PWR
HI
BACK
BACK
ID SET
TIMER
ID AN NO UNCE
MODE/REMOTE
DP-ID
ID M OD E

SQL
R-OFF
T-OFF
DEVIATION
WIDE
DTMF
*2222
*3333
*4444
1
DEACTIVATE
FIX DIGITAL
AUTO
REG
DP-ID LIST
FT2DR xxxxx
2
FT1XDR xxxxx
4
Touch the desired DP-ID to delete.
DELETE (Deletion Confirmation Screen) appears.
5 Touch the
[
OK?
]
to delete or touch the
[
Cancel
]
to return to the DP-ID
list screen without deleting.
• If deleting another transceiver, repeat step 4 to 5.
6
Touch
[
BACK
]
.
The screen returns to the setup screen.
DTMF
*2222
*3333
*4444
1
DEACTIVATE
FIX DIGITAL
AUTO
REG
DP-ID LIST
FT2DR xxxxx
2
FT1XDR xxxxx
O K ? Cance
DELETE
• If using the DP-ID, select the FIX Digital mode in the operation mode screen. When transmitting the DP-ID
signal, set the transceiver to C4FM mode.
The system manager may control the repeater setting remotely from designated transceivers by using this
function.
The transceivers compatible with the remote-control is the FTM-400D, FTM-100D, FTM-3200D and FTM-
3207D.
Example:
• Sets the repeater function ON or OFF
• Changing Downlink Transmission Power
• Setting of the Emergency Call