Operation Manual

When controlling remotely with the FTM-3207D

1 Please confirm that the FTM-3207D DP-ID is registered on DR-1X repeater.

Tune the transmit frequency of the FTM-3207D to the uplink frequency of the DR-1X.

3 Set the FTM-3207D to the digital mode, then press and hold the “Û” key on the microphone (MH-48A6JA).

4 “REMOTE” is displayed on the screen of the FTM-3207D, the remote-control is available.

• Cancelling the remote-control, press the “Û” key on the microphone (MH-48A6JA).

5 Input the 4-digits remote command by using the numeric key (MH-48A6JA).

• Press the “Û” key on the microphone (MH-48A6JA) to cancel the input command at any point in the process.

6 Press the “#” key on the microphone (MH-48A6JA) to transmit the input command.

7 After transmitting the command, press the “Û” key on the microphone (MH-48A6JA) to return to the normal

operation.

z If the FTM-3207D firmware is not compatible with the DP-ID function, update to the latest firmware to use the DP-ID

function.

z The latest firmware is available on the YAESU website.

Remote Control for Analog FM

In analog FM mode, the ON/OFF setting of the repeater can be operated remotely.

Remote Control can only be operated from a transceiver* capable of sending a code combining two CTCSS

tones.

*: FT2D/DE, FT1XD/DE, FTM-400XDR/XDE, FTM-100DR/DE, FTM-3200DR/DE, and FTM-3207DR/DE.

1 Set the same code that is registered in the DR-1X into the transceiver that can transmit the two combined

CTCSS tones.

Function Code

Activate the repeater operation The same code as “ACTIVATE” of DR-1X

Deactivate the repeater operation The same code as “DEACTIVATE” of DR-1X

For instructions on setting the codes, refer to the Transceiver Operating Manual.

2 Set the transceiver to the analog FM mode.

3 When the remote operation code is accepted, the CW ID of the operation that has been completed is

transmitted on the repeater downlink frequency.

Description CW ID

When the repeater operation is resumed CW “O” (– – –) is transmitted

When the repeater operation is stopped CW “S” (• • •) is transmitted