Operation Manual

DR-2X / DR-2XE Operating Manual36
Set the tone signal type for analog FM mode
1 Touch
[
A SETUP
]
or
[
B SETUP
]
, then touch
[
F
]
, and then touch
[
SQL
]
.
2 Select
[
RX SQL
]
to set the tone signal type during reception, or select
[
TX SQL
]
to set the tone signal type during transmission.
3 Touch
[
▲
]
or
[
▼
]
.
The setting will change in the following sequence each time
[
▲
]
or
[
▼
]
is
touched.
RX SQL: à “OFF” à “TONE” à “DCS” à “T-CALL” à “T-CALL+TONE”
à “T-CALL+DCS” à
TX SQL: à “OFF” à “TONE” à “DCS” à
4 Touch
[
BACK
]
3 times.
The setting is determined and the display will return to the operation mode screen.
z Factory default: OFF
z When “T-CALL” is set, the relay starts after receiving 1750 Hz Tone Burst more than 0.5 second. When “T-CALL+TONE”
or “T-CALL+DCS” is set, either T-CALL/TONE or T-CALL/DCS relays to receive.
z Both TX and RX can be set to different tone signal type.
z This item may be set separately on CH-A and CH-B.
Set the ID announcement for analog FM mode
Set the announcement mode
1 Touch
[
A SETUP
]
or
[
B SETUP
]
, then touch
[
F
]
, and then touch
[
ID ANNOUNCE
]
.
2 Touch
[
ANNOUNCE
],
then touch
[
ANNOUNCE MODE
]
.
The set value will change in the following sequence each time
[
ANNOUNCE MODE
]
,
[
▲
],
or
[
▼
]
is touched.
à “CW” à “CW wo TONE” à “VOICE”
ø
à
à “VC wo TONE”
ø
(VOICE wo TONE) à
ø: Requires optional Voice Guide Unit FVS-2.
3 Touch
[
ANNOUNCE LEVEL
]
.
The set value will change in the following sequence each time
[
ANNOUNCE LEVEL
]
,
[
▲
],
or
[
▼
]
is touched.
à “HIGH” à “MID” à “LOW” à
4 Touch
[
CW ID SPEED
]
.
The set value will change in the following sequence each time
[
CW ID SPEED
]
,
[
▲
],
or
[
▼
]
is touched.
à “16wd/min” à “20wd/min” à “24wd/min” à “32wd/min” à
5 Touch
[
BACK
]
4 times.
The setting is determined and the display will return to the operation mode screen.
z Factory default:
ANNOUNCE MODE: CW
ANNOUNCE LEVEL: MID
CW ID SPEED: 20wd/min
z This setting item is common to CH-A and CH-B.
z When operating in the USA the CW ID SPEED setting time must not exceed 20 words per minute when keyed by an
automatic device, to comply with the FCC rule Part 97: Sec. 97.119 (b)(1) Station identification.

8
4



DG-ID
T-OFF
R-OFF
SETUP RXx.xx TX .x

8
4



DG-ID
T-OFF
R-OFF
SETUP RXx.xx TX .x