Operation Manual

DR-2X / DR-2XE Operating Manual40

18. Connect to the HRI-200 node station

To use WIRES-X with DR-2X/DR-2XE, connect HRI-200 directly to the 10-pin plug on the back of the DR-2X/

DR-2XE.

Alternatively, there is a method the HRI-200 Node station may be located in a place different from the repeater

site. In either case, you cannot use the HRI-200 when a LAN Unit “LAN-01A” is used.

Since the repeater site does not normally have a large capacity Internet line, and the HRI-200 must always be

connected to the computer, it may be advantageous to set up the HRI-200 in a different location and uplink it

to the repeater with the Node Station transceiver. It is recommended to downlink and connect to WIRES-X.

For HRI-200 and WIRES-X, please refer to their respective instruction manuals.

The following explains how to connect HRI-200 directly to DR-2X/DR-2XE.

Connecting HRI-200 to DR-2X/DR-2XE

Type B plug

USB cable (supplied with HRI-200)

Mini-DIN digital cable

(supplied with HRI-200)

10 pin plug

To the Internet

LAN cable

(sold separately)

Type A plug