Operation Manual

18 FT-1802M OPERATING MANUAL
LOCK FEATURE
To order to prevent accidental frequency change or inadvertent transmission, various as-
pects of the FT-1802M’s keys and knob may be locked out.
To lock out some or all of the keys, use the “Set” (Menu) mode, described below:
1. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “26 LOCK.”
2. Press the
[
MHz
(
SET
)]
key, then rotate the DIAL knob to
select the desired lockout combination.
KEY: Just the front panel keys are locked out.
DIAL: Just the front panel DIAL knob is locked out.
K+D: Both the keys and DIAL knob are locked out.
PTT: The PTT switch is locked (TX not possible).
K+P: Both keys and PTT switch are locked out.
D+P: Both DIAL knob and PTT switch are locked out.
ALL: All of the above are locked out.
OFF: The Lock feature is disabled.
3. Press and hold in the
[
MHz
(
SET
)]
key for one second to save your new setting and exit
to normal operation.
When the Lock feature is activated, the “ ” icon will appear
on the LCD.
To disable the Lock feature, repeat the above process, selecting “OFF” in step 2 above.
KEYBOARD BEEPER
A key/button beeper provides useful audible feedback whenever a key/button is pressed. If
you want to turn the beeper off (or back on again):
1. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “6 BEEP.”
2. Press the
[
MHz
(
SET
)]
key, then rotate the DIAL knob to
set the display to “OFF.”
3. Press and hold in the
[
MHz
(
SET
)]
key for one second to save your new setting and exit
to normal operation.
4. To turn the beep back on again, select “KEY” or “KY+SCN (factory default)” in step 4
above.
KEY: The beeper sounds when you press the keypad.
KY+SCN: The beeper sounds when you press the keypad, or when the scanner stops.
ADVANCED OPERATION