Operation Manual

38 FT-1802M OPERATING MANUAL
MEMORY BANK OPERATION
The large number of memories available in the FT-1802M could be difficult to utilize with-
out some means of organizing them. Fortunately, the FT-1802M includes provision for
dividing the memories into as many as eight Memory Banks, so you can categorize the
memories in a manner convenient to you. You may enter and exit the “Memory Bank” mode
by a single press of the Microphone’s
[

]
key, as we shall see below.
Assigning Memories to a Memory Bank
1. Recall the memory channel to be assigned to a Memory
Bank.
2. Press and hold in the
[
D/MR
(
MW
)]
key for one second, then rotate the DIAL knob to
select the Memory Bank number (“b1” ~ “b8”) you want as
the Memory Bank for this channel. The Memory Bank num-
bers are found by rotating the DIAL knob counter-clockwise past memory channel “0.”
3. Press the
[
D/MR
(
MW
)]
key momentarily to copy the memory channel data into the Memory
Bank.
1) You may assign one memory channel into several Memory Banks.
2) The PMS memory channels (L0/U0 through L9/U9) may not be assigned to a
Memory Bank.
Memory Bank Recall
1. Press the
[
D/MR
(
MW
)]
key, if needed, to enter the Memory
mode.
2. Press the Microphone’s
[

]
key to activate the “Memory
Bank” mode. The Memory Bank number will appear on the
display.
3. Press the
[
#
]
key to increment the Memory Bank (“b1”
through “b8”).
4. Rotate the DIAL knob to select the memories within the
selected Bank; you will observe that you can only select memory channels in the current
memory bank. The small memory bank number will appear, to the right of the frequency
display, two seconds after you complete memory channel selection while operating within
a Memory Bank.
5. To change to another Memory Bank, press the
[
#
]
key to
step up to the next-highest bank.
6. To exit from Memory Bank operation, just press the Microphone’s
[

]
key. The Memory
Channel number will appear steadily on the right side of the display, indicating that you are
now in the “standard” Memory Recall mode, without utiliza-
tion of the Memory Banks. The memories stored in the vari-
ous Banks will remain in those banks, however; you do not need to store them again.
MEMORY OPERATION