Operation Manual

FT-252 OperaTing Manual46
CW Identier Setup
The ATS feature and Emergency channel operation includes a CW identifier, as dis-
cussed previously. Every ten minutes during ATS operation or every one minute during
Emergency channel operation, the radio can be instructed to send “DE (your callsign)
K” (ATS feature) and “SOS DE (your callsign)” (Emergency channel operation) if this
feature is enabled. The callsign eld may contain up to 6 characters.
Here’s how to program the CW Identier:
1. Press the
[
SET/ATS
]
key to enter the Set mode.
2. Rotate the
DIAL
knob or press the
[
p
]
/
[
q
]
key to select
Set Mode Item 10:
CW WRT
.
3. Press the
[
SET/ATS
]
key momentarily to display any
previously-stored callsign.
4. Press the
[
F/MW
]
key again to clear any previous callsign.
5. Rotate the
DIAL
knob to select the rst letter/number of
your callsign, then press the
[
F/MW
]
key momentarily to
save the rst letter/number and move on to the next char-
acter.
6. Repeat the previous step, as many times as necessary, to
complete your callsign. If you make a mistake, press the
[
q
]
key to move back to the previous letter/number’s slot,
then re-select the correct letter/number.
7. When you have nished entering your entire callsign and
it contains less than 6 characters, press and hold in the
[
F/
MW
]
key for one second to conrm the callsign. (if you
callsign has exactly 6 characters, you do not need to press and hold in
[
F/MW
]
in this
step).
8. Press the
PTT
switch to save the settings and exit to normal operation.
9. Press the
[
SET/ATS
]
key to enter the Set mode.
10. Rotate the
DIAL
knob or press the
[
p
]
/
[
q
]
key to select
Set Mode Item 11:
CWID
.
11. Press the
[
SET/ATS
]
key momentarily, then rotate the
DIAL
knob to set this Item to “
TX ON
” (to enable the CW
ID function).
12. Press the
PTT
switch to save the settings and exit to normal operation.
Miscellaneous Settings
honbun_130313.indd 46 2013/03/13 19:48:07