Operation Manual

32 FT-2800M OPERATING MANUAL
While operating in the Memory Recall mode, press and hold in the
[
LOW
(
A/N
)]
key for one
second to toggle the display between indication of the frequency and the channel’s Alpha/
Numeric label.
Memory Tuning
Once you have recalled a particular memory channel, you may easily tune off that channel,
as though you were in the VFO mode.
1. With the FT-2800M in the Memory Recall mode, select the desired memory channel.
2. Press the
[
MHz
(
SET
)]
key momentarily. The “MR” indicator will blink; this indicates
that the Memory Tuning” mode has been engaged.
3. Rotate the DIAL knob, or press the
[
UP
]
or
[
DWN
]
keys, to tune to a new frequency. The
synthesizer steps you have selected for VFO” operation will be the steps used during
Memory Tuning.
4. If you wish to return to the original memory frequency, press the
[
D/MR
(
MW
)]
key
momentarily. The “MR” indicator will stop blinking.
5. If you wish to store into memory a new frequency set during Memory Tuning, just press
and hold in the
[
D/MR
(
MW
)]
key for one second, then complete the normal memory
storage procedure. Be sure to select an open memory channel when doing so.
Deleting Memories
With 221 total memories available, there frequently are situations where you may desire to
delete certain memories temporarily (except the Memory Channel “00” and Home Chan-
nel). The procedure for deleting a channel is quite simple:
1. With the FT-2800M in the Memory Recall mode, press and hold in the
[
D/MR
(
MW
)]
key for one second, then rotate the DIAL knob to select the memory channel you wish to
delete.
2. Press the
[
LOW
(
A/N
)]
key momentarily. The “CLEARnotation will appear on the dis-
play.
3. Press again the
[
LOW
(
A/N
)]
key momentarily. The previously-selected memory will be
deleted.
Once deleted, channel data cannot be recovered!
MEMORY RECALL
MEMORY OPERATION