Operation Manual

22 FT-2900R OPERATING MANUAL
REPEATER OPERATION
AUTOMATIC REPEATER SHIFT
The ARS (Automatic Repeater Shift) feature in this transceiver allows easy and convenient
repeater operation by automatically activating the repeater shift function whenever you
tune to a standard repeater subband. The ARS function is preset at the factory to conform to
the standards for the country to which it is exported.
The ARS function is enabled at the factory. To disable it:
1. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “
4 ARS4 ARS
4 ARS4 ARS
4 ARS.”
2. Press the
[
MHz
(
SET
)]
key, then rotate the DIAL knob to
change the display to “
OFFOFF
OFFOFF
OFF.”
3. Press and hold in the
[
MHz
(
SET
)]
key for one second to
save your new setting and exit to normal operation.
To enable the ARS function again, select “
ONON
ONON
ON” in step 2 above.
CHECKING THE REPEATER UPLINK
(
INPUT
)
F
REQUENCY
It often is helpful to be able to check the uplink (input) frequency of a repeater, to see if the
calling station is within direct (“Simplex”) range.
To do this, just press the
[
REV
(
DW
)]
key. You’ll notice that the display has shifted to the
repeater uplink frequency. Press the
[
REV
(
DW
)]
key again to cause operation to revert to
normal monitoring of the repeater downlink (output) frequency. While you are listening on
the input frequency to the repeater using the
[
REV
(
DW
)]
key, the repeater offset icon will
blink.
European Version
Version A
145.1 145.5
145.6 145.8
146.0 146.4 147.0 147.6 148.0
146.6 147.4
ARS-Repeater Subbands