Operation Manual

35FT-2900R OPERATING MANUAL
STORING INDEPENDENT TRANSMIT FREQUENCIES
(
“ODD SPLITS”
)
1. Store the receiving frequency using the method already described.
2. Tune to the desired transmit frequency, then press and hold in the
[
D/MR
(
MW
)]
key for
one second.
3. Within five seconds of pressing the
[
D/MR
(
MW
)]
key, use the DIAL knob or micro-
phone
[
UP
]
/
[
DWN
]
buttons to select the same memory channel number used in step 1
above.
4. Press and hold in the PTT switch, and press the
[
D/MR
(
MW
)]
key momentarily while
holding in the PTT switch. This will not cause transmission, but rather it will instruct
the transceiver that you are programming a separate transmit frequency into memory.
Whenever you recall a memory which contains independently-
stored transmit and receive frequencies, the “ ” indication
will appear in the display.
The “Odd Splits” feature can store separate CTCSS/DCS functions for the receive and
transmit frequencies.
When you recall a memory channel which contains indepen-
dently stored CTCSS/DCS information, the decoder icon will
appear solid, and the encoder icon will blink on the display.
To confirm the memorized frequency/code:
1. Press and hold in the
[
MHz
(
SET
)]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select “
14 DCS CD14 DCS CD
14 DCS CD14 DCS CD
14 DCS CD” when the
receiver CTCSS/DCS function is set to “DCS”, or select
“
52 TN FRQ52 TN FRQ
52 TN FRQ52 TN FRQ
52 TN FRQ” when the receiver CTCSS/DCS function is
set to “TONE SQUELCH”.
3. Press the
[
MHz
(
SET
)]
key momentarily to indicate the
memorized frequency/code for the receiver.
4. Press the
[
REV
(
DW
)]
key to indicate the memorized fre-
quency/code for the transmitter. You can confirm the Trans-
mit and Receive TONE/DCS by alternately pressing of the
[
REV
(
DW
)]
key.
MEMORY OPERATION
: Receive tone/DCS
: Transmit tone/DCS