Operation Manual

36 FT-2900R OPERATING MANUAL
MEMORY RECALL
Once you have stored the memory or memories desired, you must now switch from the
“VFO” mode to the “Memory Recall” mode, so you can operate on the just-stored memory
channels.
1. Press the
[
D/MR
(
MW
)]
key, repeatedly if necessary, until
the “MR” icon and a memory channel number appear on
the display; this indicates that the “Memory Recall” mode
is now engaged.
2. When more than one memory has been stored, use the DIAL knob to select any of the
programmed memories for operation. Alternatively, the microphone’s
[
UP
]
or
[
DWN
]
button may be used to step or scan through the available memories. When using the
microphone’s buttons, press the button momentarily to move one step up or down; press
and hold in the
[
UP
]
or
[
DWN
]
button for one second to begin memory scanning.
Memory Recall from the Microphone’s Keypad:
While operating in the Memory Recall mode, the keypad of the MH-48A6J Microphone
may be used for direct recall of memory channels.
To do this, press the Channel Number you wish to recall, then press the
[
#
]
key. For ex-
ample, to recall Memory Channel “5,” press
[
5
]
Æ
[
#
]
. To recall Memory Channel “118,”
press
[
1
]
Æ
[
1
]
Æ
[
8
]
.
You may also recall Programmable Memory Scan (PMS) channels (“
L0L0
L0L0
L0/
U0U0
U0U0
U0” through “
L9L9
L9L9
L9/
U9U9
U9U9
U9”) using the following numbers: Programmable Memory channels #
L0L0
L0L0
L0 = “200,”
U0U0
U0U0
U0 =
“201,”
L9L9
L9L9
L9 = “218,” and
U9U9
U9U9
U9 = “219.”
MEMORY OPERATION