Operation Manual

40 FT-2900R OPERATING MANUAL
Removing Memories from a Memory Bank
1. While operating in the Memory Bank mode, recall the memory channel to be removed
from a Memory Bank.
2. Press and hold in the
[
D/MR
(
MW
)]
key for one second, then press the
[
A/N
(
LOW
)]
key to
remove the memory channel data from the Memory Bank.
You must first enter the Memory Bank mode, by pressing the microphone’s
[
½½
½½
½
]
key
, before attempting to remove a channel from a
Bank. If you don’t, “MCHERR” will appear when you press
the
[
A/N
(
LOW
)]
key in step
(
2
)
above.
Changing a Memory Bank’s Name
You may change the default Memory Bank Name, which is indicated on the display when
you’ve selected a Memory Bank, to a different name, if desired.
1. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “
9 BNK NM9 BNK NM
9 BNK NM9 BNK NM
9 BNK NM.”
2. Press the
[
MHz
(
SET
)]
key momentarily, then rotate the
DIAL knob to recall the memory bank on which you wish
to change a label.
3. Press the
[
A/N
(
LOW
)]
key to enable changing of the name tag.
4. Rotate the DIAL knob to select the first digit of the desired
label.
5. Press the
[
A/N
(
LOW
)]
key to move to the next character.
6. If you make a mistake, press the
[
REV
(
DW
)]
key to back-space the cursor, then re-enter
the correct letter, number, or symbol.
7. Repeat steps 4 through 6 to program the remaining letters,
numbers, or symbols of the desired label. A total of six char-
acters may be used in the creation of a label.
8. When you have programmed a name which is under 6 characters, press and hold in the
[
MHz
(
SET
)]
key for one second to confirm the label and exit to normal operation.
MEMORY OPERATION
MEMORY BANK OPERATION