Operation Manual

45FT-2900R OPERATING MANUAL
SCAN-RESUME OPTIONS
Three scan-resume modes are available on the FT-2900R:
 In the “
BUSYBUSY
BUSYBUSY
BUSY” mode, the scanner will remain halted for as long as there is carrier present
on the channel; after the carrier drops at the end of the other station’s transmission,
scanning will resume.
 In the “
HOLDHOLD
HOLDHOLD
HOLD” mode, the scanner will halt on a signal it encounters. It will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
 In the “
3SEC3SEC
3SEC3SEC
3SEC/
5SEC5SEC
5SEC5SEC
5SEC/
10SEC10SEC
10SEC10SEC
10SEC” mode, the scanner will halt for the selected resume time,
after which scanning will resume (whether or not the other station is still transmitting).
The default scan-stop mode is “
BUSYBUSY
BUSYBUSY
BUSY.” To change the scan-resume mode, use the following
procedure:
1. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “
41 RESUME41 RESUME
41 RESUME41 RESUME
41 RESUME.”
2. Press the
[
MHz
(
SET
)]
key, then rotate the DIAL knob to
select the desired scan-resume mode.
3. Press and hold in the
[
MHz
(
SET
)]
key for one second to
save the new setting and exit to normal operation.
SCANNING