Operation Manual

48 FT-2900R OPERATING MANUAL
MEMORY BANK LINK SCAN
When the Memory Bank feature is engaged, the scanner sweeps only memory channels in
the current Memory Bank. However, if the Memory Bank Link Scan feature is enabled, you
may sweep the memory channels in several Memory Banks which you have selected.
To enable the Memory Bank Link Scan feature:
1. Set the radio to the Memory mode by pressing the
[
D/MR
(
MW
)]
key, if necessary.
2. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “
8 BNK.LNK8 BNK.LNK
8 BNK.LNK8 BNK.LNK
8 BNK.LNK.”
3. Press the
[
MHz
(
SET
)]
key momentarily, then rotate the
DIAL knob to select the first Memory Bank (“
b1b1
b1b1
b1” ~ “
b8b8
b8b8
b8”)
you wish to sweep using Memory Bank Link Scan.
4. Press the
[
D/MR
(
MW
)]
key momentarily. A “SKIP” icon
will blink above the Memory Bank number, indicating this
Memory Bank will now be swept during Memory Bank
Scan.
5. Repeat steps 3 and 4 above, to append the blinking “SKIP”
icon to any other Memory Banks you wish to sweep.
6. Now, press and hold in the
[
MHz
(
SET
)]
key for one sec-
ond to initiate the Memory Bank Link Scan.
7. To remove a Memory Bank from the Memory Bank Link Scan, repeat steps 2 - 4 above,
to delete the blinking “SKIP” icon from the Memory Bank number indication.
SCANNING