Operation Manual

61FT-2900R OPERATING MANUAL
The FT-2900R may be used for 1200 bps Packet operation, using most all commonly-
available Terminal Node Controllers (TNCs). Connections between the transceiver and the
TNC are accomplished via the front panel Microphone connector and rear panel External
Speaker jack, per the diagram below.
The audio level from the receiver to the TNC may be adjusted by using the VOL knob, as
with voice operation. The input level to the FT-2900R from the TNC may be adjusted via
Set Mode Item “
27 MCGAIN27 MCGAIN
27 MCGAIN27 MCGAIN
27 MCGAIN;” see page 64 for details.
Be sure to turn the transceiver and TNC off before connecting the cables, so as to prevent
voltage spikes from possibly damaging your transceiver.
Remember to readjust the default microphone input level to “LVL 5” (Set Mode Item “
2727
2727
27
MCGAINMCGAIN
MCGAINMCGAIN
MCGAIN”) when Packet operation is finished.
PACKET OPERATION