Operation Manual

67FT-2900R OPERATING MANUAL
DCS CODE INVERSION
The DCS system was first introduced in the commercial LMR (Land Mobile Radio) service,
where it is now in widespread use. DCS is sometime referred to by its different proprietary
names, such as DPL
®
(Digital Private Line
®
, a registered trademark of Motorola, Inc.).
DCS uses a codeword consisting of a 23-bit frame, transmitted (subaudible) at a data rate of
134.4 bps (bit/sec). Occasionally, signal inversion can result in the complement of a code to
be sent or received. This prevents the receiver’s squelch from opening with DCS enabled,
as the decoded bit sequence would not match that selected for operation.
Typical situations that might cause inversion to occur are:
 Connection of an external receiver preamplifier.
 Operating through a repeater.
 Connection of an external linear amplifier.
Note that code inversion does not mean that any of the above listed equipment is defective!
In certain amplifier configurations, the output signal (phase) is inverted from the input.
Small signal or power amplifiers having an odd number (1, 3, 5, etc.) of amplification
stages may result in inversion of a transmitted or received DCS code.
While under most circumstances this should not occur (amplifier designs and industry stan-
dards take this into account), if you find that your receiver squelch does not open when both
you and the other station are using a common DCS code, you or the other station (but not
both) can try the following:
1. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “
15 DCS RV15 DCS RV
15 DCS RV15 DCS RV
15 DCS RV.”
2. Press the
[
MHz
(
SET
)]
key momentarily, then rotate the
DIAL knob to set this Set Mode Item to “
ENABLEENABLE
ENABLEENABLE
ENABLE” (thus
inverting the DCS Code).
3. When you have made your selection, press and hold the
[
MHz
(
SET
)]
key for one sec-
ond to save the new setting and exit to normal operation.
4. Remember to restore the default setting to “
DISABLEDISABLE
DISABLEDISABLE
DISABLE” when done.
MISCELLANEOUS SETTINGS