Operation Manual

Page 86 FT-450 OPERATION MANUAL
CLONING
You can transfer all data stored in one transceiver to another set by utilizing the handy “Cloning” feature. This
requires a user supplied cloning cable, which connects the CAT jacks on the two transceivers, as shown below.
To clone from one transceiver to another, use the following procedure:
1. Insert the D-SUB 9pin cross cable (User Supplied)
into the CAT jack of each transceiver.
2. Turn both transceivers off, then press and hold in
the
[
MODE
]
and
[
MODE
]
buttons on each ra-
dio while turning the power on again. The “cLonE
C.S-SND” notation will appear on the display.
3. On the “Source” radio, press the
[
VOICE/C.S
]
button.
4. Data will now be transferred to the “Destination”
radio from the “Source” radio.
When the clone completes successfully, “CLonE
SENDING” is displayed on the display.
If there is a problem during the cloning process,
“Error” will be displayed. Check your cable con-
nections and try again.
5. If cloning is successful, turn the “Destination” ra-
dio off, and “cLonE C.S-SND” notation will reappear
on the “Source” radio.
6. Turn the “Source” radio off.
7. Remove the clone cable. The channel and oper-
ating data for both radios are now identical. Both
radios may be turned on now for normal opera-
tion.
INPUT
DC 13.8V
22A
ANT
GND
EXT
SPKR
CATLINEARTUNERDATA
INPUT
DC 13.8V
22A
ANT
GND
EXT
SPKR
CATLINEARTUNERDATA
D-SUB 9pin cross cable (User Supplied)
[
VOICE/C.S
]
button
“Destination”
“Source” Press the [VOICE/C.S] button
[MODE] and [MODE] buttons
[
ON/OFF
]
button