Operation Manual

FT-60R/E OPERA TING MANUAL 53
CW Identifier Setup
The ARTS™ feature includes a CW identifier, as discussed previously. Every ten minutes
during ARTS™ operation, the radio can be instructed to send “DE (your callsign) K” if
this feature is enabled. The callsign field may contain up to 6 characters.
Here’s how to program the CW Identifier:
1. Press the
[
F/W
]
key, then press the
[
0
( )
SET
]
key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 11: CW WRT.
3. Press the
[
F/W
]
key momentarily to display any previously-
stored callsign.
4. Press the
[
F/W
]
key again to clear any previous callsign.
5. Rotate the DIAL knob to select the first letter/number of your
callsign, then press the
[
F/W
]
key momentarily to save the first
letter/number and move on to the next character.
6. Repeat the previous step, as many times as necessary, to com-
plete your callsign. If you make a mistake, press the
[

(
MHz
)]
key to move back to the previous letter/number’s slot, then re-
select the correct letter/number.
7. When you have finished entering your entire callsign and it con-
tains less than 6 characters, press and hold in the
[
F/W
]
key for one second to confirm
the callsign. (if you callsign has exactly 6 characters, you do not need to press and
hold in
[
F/W
]
in this step).
8. Press the PTT switch to save the settings and exit to normal operation.
9. Press the
[
F/W
]
key, then press the
[
0
( )
SET
]
key to enter the Set mode again.
10. Rotate the DIAL knob to select Set Mode Item 10: CWID.
11. Press the
[
F/W
]
key momentarily to enable adjustment of this
Set Mode Item.
12. Rotate the DIAL knob to set this Item to “TX ON” (to enable the
CW ID function).
13. Press the PTT switch to save the settings and exit to normal
operation.
You may check your work by monitoring the entered callsign. To do this,
repeat steps 1- 7 above, then press the MONI switch.
ARTS™
(
A
UTOMATIC RANGE TRANSPONDER SYSTEM
)