Extra Information

24
FT-70DR/DE Advance Manual
Reset All
Use this procedure to restore all settings to their original factory defaults. All Memories
will be cleared by this procedure.
CAUTION!
Resetting will clear all memories and all settings to the factory default. Be sure to make a note of the
Memory Channel and Set Mode settings, etc. before resetting.
1. Turn the transceiver OFF.
2. Press and hold the
[
MODE
]
key,
[
HM/RV
]
key and
the
[
AMS
]
key simultaneously, while turning the
transceiver ON.
The beep sounds and the confirmation screen is
displayed.
3. Press the
[
F
]
key to sound beep and reset all fac-
tory defaults.
• After resetting all defaults, the call sign input
message appears on the LCD. Set the call sign.
(See the operating manual)
To cancel the resetting, press any key except the
[
F
]
key.
Set Mode Reset
The Set mode only reset will restore all the Set Mode Items to the default settings. The
user memory channels will not be reset.
CAUTION!
Resetting will clear all Set Mode MENU items to the factory default. Be sure to make a note of any
user customized Set Mode settings, etc. before resetting.
1. Turn the transceiver OFF.
2. Press and hold the
[
MODE
]
key and the
[
V/M
]
key
and turn the transceiver ON simultaneously.
The beep sounds and the confirmation screen is
displayed.
3. Press the
[
F
]
key to sound a beep and reset the
Set Mode settings.
To cancel the resetting, press any key except the
[
F
]
key.
The Set Mode Reset may not reset the following Set Mode items.
To restore all of the following Set Mode items to default, perform All Reset:
1 ANT.ATT 8 BELL 9 BNK.NAM 11 CLK.SFT 13 DCS.INV
17 DP-ID 19 DT SET 33 MEM.NAM 35 NM/FRQ 36 OPN.MSG
37 PAG.ABK 38 PAG.CDR 39 PAG.CDT 41 PSWDWT 44 RF SQL
46 RPT.FRQ 47 RX MOD 49 SCM.WTH 50 SCV.WTH 54 SQL.EXP
62* (61) W/N.DEV 64* (63) MYCALL
*: USA Version