Extra Information

44
FT-70DR/DE Advance Manual
Clone Operation
Data and various settings saved in your transceiver may be copied to any other FT-
70DR/DE transceiver.
CT-27 (option)
MIC/SP MIC/SP
1. Turn off the power of both FT-70DR/DE transceivers,
2. Remove the rubber cap from the MIC/SP jack of the each transceivers, then connect
the optional clone cable (CT-27).
3. While pressing and holding the
[
F
]
key, turn the each transceivers ON.
The “CLONE” is displayed on the LCD, then the transceiver enters the clone mode.
4. Press the
[
MODE
]
key on the receiving side transceiver.
The “--WAIT--” is displayed on the receiving transceiver
5. Press the
[
BAND
]
key on the transmitting transceiver.
• The “--TX--” is displayed on the transmitting transceiver and then data copy starts.
• The display on the receiving transceiver changes from “--WAIT--” to “--RX--”.
• When data transmission begins, the transmission data amount bar graph appears
on the LCD.
6. When copying is completed, the receiving side transceiver returns to the normal
mode. On the transmission side transceiver, the indication on the LCD returns from
“--TX--” to “CLONE”.
7. Turn off the power of both transceivers, then disconnect the clone cable.
When the “ERROR” appears on the LCD during data transfer, copying cannot be completed.
Check the clone cable connection, and redo the operation from the beginning.