Operation Manual
25FT-70DR/FT-70DE Operating Manual
Registering to Memory Channels
1. Set the frequency and the communication mode
to be registered to a memory channel.
2. Press the
[
V/M
]
key.
“
” blinks on the LCD.
3. Rotate the DIAL knob to select the desired
channel number.
The channel numbers that do not contain mem-
ory data will blink on the LCD.
4. Press the
[
V/M
]
key.
• If you attempt to register a frequency to a
memory channel that already contains fre-
quency data, “M-WRT?” will appear on the
LCD. Press the
[
V/M
]
key to overwrite the
memory channel.
• The memory tag input screen will be displayed on the LCD.
5. Input the memory tag.
• Use the numeric keys or the DIAL knob to in-
put the characters.
Memory Channel
Number
• Example: Rotating the DIAL knob to display the following characters.
A - Z
(
symbol
)
0 - 9
(
symbol
)
A - Z
• Example:
Press the
[
2
]
key repeatedly to toggle among the following available characters.
A → B → C → 2 → A
···
• Moving the cursor and deleting the input characters
[
BAND
]
key: Moves the cursor to the right
[
MODE
]
key: Moves the cursor to the left
[
GM
]
key
(
press and hold
)
: Erases all characters after the cursor
6. Press and hold the
[
V/M
]
key.
The beep sounds and the memory is saved.
Recalling a Memory Channel
1. Press the
[
V/M
]
key.
The memory channel most recently used appears on the LCD.
2. Rotate the DIAL knob to select the desired memory channel, or input the 3 digits of
the memory channel using the numeric keys to recall the memory channel directly.
3. Press the
[
V/M
]
key to exit the memory mode, and return to the normal operation.
z
The data registered to a memory channel can be transferred to the VFO operating band by
following the procedure below:
Press and hold the
[
V/M
]
key
Rotate the DIAL knob to select the channel
Press and hold
the
[
GM
]
key
“V-WRT?” appears
Press the
[
GM
]
key.
z
Pressing the
[
F
]
key and then rotating the DIAL knob allows skipping memory channels quickly
in steps of 10 memory channels.
z
The transceiver may be placed into a Memory Channel Only mode,
(
which restricts the FT-70DR/DE
to operate only on the memory channels
)
, by pressing the
[
V/M
]
key, while pressing the Power
(
Lock
)
switch to turn the transceiver ON. To cancel the Memory Channel Only mode, turn the transceiver
OFF, then press the
[
V/M
]
key again, while pressing Power
(
Lock
)
switch to turn the transceiver ON.