Operation Manual

38 FT-70DR/FT-70DE Operating Manual
Restoring to Defaults
(
Reset
)
All Reset
To restore all transceiver settings and memory content to the factory defaults.
CAUTION!
Resetting the transceiver will clear all memories.
Please make a note of the memories
(
memory channel settings, etc
)
before resetting.
1. Turn the transceiver OFF.
2. Press and hold the
[
MODE
]
key, the
[
HM/RV
]
key and the
[
AMS
]
key and turn the transceiver
ON simultaneously.
The beep sounds and the confirmation
screen is displayed.
3. Press the
[
F
]
key.
• The beep will sound, and the transceiver
will reset all factory defaults.
• After resetting all defaults, the call sign
input message appears on the LCD. Set
the call sign
(
14
)
.
To cancel the resetting, press any key except the
[
F
]
key.
Set Mode Reset
All the Set mode only, settings can be restored to the default settings.
1. Turn the transceiver OFF.
2. Press the
[
MODE
]
key and the
[
V/M
]
key and
turn the transceiver ON simultaneously.
The beep sounds and the confirmation
screen is displayed.
3. Press the
[
F
]
key then the beep sounds and
all Set mode settings are reset to defaults.
Perform All Reset to restore all of the following Set Mode items to default.
1 ANT.ATT 8 BELL 9 BNK.NAM 11 CLK.SFT 13 DCS.INV
17 DP-ID 19 DT SET 33 MEM.NAM 35 NM/FRQ 36 OPN.MSG
37 PAG.ABK 38 PAG.CDR 39 PAG.CDT 41 PSWDWT 44 RF SQL
46 RPT.FRQ 47 RX MOD 49 SCM.WTH 50 SCV.WTH 54 SQL.EXP
62*
(
61
)
W/N.DEV 64*
(
63
)
MYCALL
*: USA Version
To cancel the resetting, press any key except the
[
F
]
key.