Operation Manual

32 FT-7800R OPERATING MANUAL
The FT-7800R provides a wide variety of memory system resources. These include:
 “Regular” Memory Channels, which includes:
 1000 “Standard” memory channels, numbered “000” through “999.”
 5 Home channels, providing storage and quick recall of one prime frequency on each
operating band.
 50 sets of band-edge memories also known as “Programmable Memory Scan” chan-
nels, labeled “L1/U1” through “L50/U50.”
 20 Memory Banks, labeled “BANK1” through “BANK20.” Each Memory Bank can
be assigned from the “Standard” Memory Channels.
 5 “Hyper-Memory” Channels
 10 “Weather Broad-
cast” Channels
MEMORY OPERATION
REGULAR MEMORY CHANNEL OPERATION
Memory Storage
1. Select the desired frequency, while operating in the VFO mode. Be sure set up any de-
sired CTCSS or DCS tones, as well as any desired repeater offset. The power level may
be also be set at this time, if you wish to store it.
2. Press and hold in the
[
V/M
(
MW
)]
key for 1/2 second. A
memory number will appear (blinking) on the display.
3. Within ten seconds of pressing the
[
V/M
(
MW
)]
key, use
the DIAL knob or the microphone’s
[
UP
]
/
[
DWN
]
buttons to select the desired memory
channel for storage (if the channel is already occupied by data stored previously, the
“channel frequency” notation will appear on the display).
4. To attach an alpha/numeric name “Tag” to the memory,
press and hold in the
[
V/M
(
MW
)]
key for 1/2 second,
then proceed to the next step; otherwise press the
[
V/M
(
MW
)]
key momentarily to save the entry and exit to normal operation.
WX10
WX9
WX8
WX7
WX6
WX5
WX4
WX3
WX2
WX1
HOME Channels
(5 channels)
L50/U50
L49/U49
L3/U3
L2/U2
L1/U1
000
999
998
003
002
001
Standard Memory Channels
(1000 channels)
PMS Memory Channels
(50 Sets)
1-HP
2-HP
3-HP
4-HP
5-HP
850 MHz Band
430 MHz Band
250 MHz Band
350 MHz Band
144 MHz Band
Regular Memory Channels
Hyper Memory Channels
(5 channels)
Weather Broadcast Channels
(10 channels)