Operation Manual

74 FT-7800R OPERATING MANUAL
Menu #40
[
SKIP
]
Function: Selects what action will happen on a “flagged” Memory Channel
Available Values: OFF/SKIP/ONLY
Default: OFF
OFF: All memory channels will be scanned (the “flag” will be ignored).
SKIP: The scanner will “skip” the flagged (“SKIP”) channels during scanning.
ONLY: The scanner will only scan the flagged (Preferential) channels during scanning.
Menu #41
[
SPLIT
]
Function: Enables/Disables split CTCSS/DCS coding.
Available Values: SPL.OFF/SPL.ON
Default: SPL.OFF
When this Menu Item is set to “ON,” you can see the following additional parameters after
the “DCS” parameter while selecting the Menu #42: SQL.TYP.
D: DCS Encode only
(the “DCS” icon will blink during operation)
ENC DCS: Encodes a CTCSS Tone and Decodes a DCS code
(the “DCS” and “ENC” icons will appear during operation)
D-DEC: Encodes a DCS code and Decodes a CTCSS Tone
(the “DCS” icon will blink and the “DEC” icon will appear during opera-
tion)
Select the desired operating mode from the selections shown above.
Menu #42
[
SQL.TYP
]
Function: Selects the Tone Encoder and/or Decoder mode.
Available Values: OFF/ENC/ENCDEC/REV TN/DCS
Default: OFF
ENC: CTCSS Encoder
ENC DEC: CTCSS Encoder/Decoder
REV TN: Reverse CTCSS Decoder
DCS: Digital Code Squelch Encoder/Decoder
Menu #43
[
STEP
]
Function: Sets the Synthesizer steps.
Available Values: AUTO/5.0 k/10.0 k/12.5 k/15.0 k/20.0 k/25.0 k/50.0 k/100 k
Default: Depends on the band of operation.
Note: 5 kHz and 15 kHz steps are not available for use on above 700 MHz.
MENU
(
“SET”
)
MODE