Operation Manual

34 FT-7900R OPERATING MANUAL
Storing Independent Transmit Frequencies (“Odd Splits”)
1. Store the receiving frequency using the method already described.
2. Turn to the desired transmit frequency, then press and hold in the
[
V/M
(
MW
)]
key for
1/2 second.
3. Within ten seconds of pressing the
[
V/M
(
MW
)]
key, use the DIAL knob or microphone’s
[
UP
]
/
[
DWN
]
buttons to select the same memory channel number as used in step 1 above.
4. Press and hold in the PTT switch, then pressing and holding the
[
V/M
(
MW
)]
key for
1/2 second while holding the PTT switch to save the entry and exit to normal operation.
This will not cause transmission; instead, it signals the microprocessor that a separate
transmit frequency is being programmed into that memory register.
Whenever you recall a memory which contains indepen-
dently-stored transmit and receive frequencies, the “ ”
indication will appear in the display.
If you set the CTCSS/DCS functions to the receiver frequency and transmit frequency indi-
vidually, the “Odd Splits” feature can be memorize the frequency/code individually for trans-
mit and receive.
Whenever you recall a memory which contains indepen-
dently-stored CTCSS/DCS functions, the decoder icon will
appear and the encoder icon will blink in the display.
To confirm the memorized frequency/code:
1. Press and hold in the
[
BAND
(
SET
)]
key for 1/2 second to enter the Set mode.
2. Rotate the DIAL knob to select Menu #9 (
DCS.CODDCS.COD
DCS.CODDCS.COD
DCS.COD)
when the receiver CTCSS/DCS function is set to “DCS”,
or select Menu #44 (
TN FRQTN FRQ
TN FRQTN FRQ
TN FRQ) when the receiver CTCSS/
DCS function is set to “TONE SQUELCH”.
3. Press the
[
BAND
(
SET
)]
key momentarily to display the
memorized frequency/code for the receiver.
4. Press and hold in the
[
TONE
(
HM/RV
)]
key for 1/2 sec-
ond to display the memorized frequency/code for the
transmitter. You can confirm the Transmit and Receive
TONE/DCS by alternately press and holding of the
[
TONE
(
HM/RV
)]
key.
5. Press and hold in the
[
BAND
(
SET
)]
key for 1/2 second to exit to normal operation.
REGULAR MEMORY CHANNEL OPERATION
MEMORY OPERATION
: Receive TONE/DCS
: Transmit TONE/DCS