Operation Manual

54 FT-7900R OPERATING MANUAL
CW Identifier Setup
The ARTS feature includes a CW identifier, as discussed previously. Every ten minutes
during ARTS operation, the radio can be instructed to send “DE (your callsign) K” if this
feature is enabled. The callsign field may contain up to 6 characters.
Here’s how to program the CW Identifier:
1. Press and hold in the
[
BAND
(
SET
)]
key for 1/2 second to enter the Set mode.
2. Rotate the DIAL knob to select Menu #8 (
CW WRTCW WRT
CW WRTCW WRT
CW WRT).
3. Press the
[
BAND
(
SET
)]
key momentarily.
4. Press the
[
BAND
(
SET
)]
key momentarily again to en-
able entry of your callsign.
5. Rotate the DIAL knob one click clockwise to begin en-
try of the letters and numbers in your callsign.
6. Press the
[
BAND
(
SET
)]
key momentarily to set the first
letter or number in your callsign.
7. When the correct character has been selected, press the
[
BAND
(
SET
)]
key momentarily to move on to the next
character.
8. Repeat steps 6 and 7 as many times as necessary to com-
plete your callsign.
9. Press the
[
SCAN
(
SEL
)]
key to delete all data after the
cursor that may have been previously stored (errone-
ously).
10. When you have entered your entire callsign, press and hold in the
[
BAND
(
SET
)]
key
for 1/2 second to confirm the callsign, then press and hold in the
[
BAND
(
SET
)]
key for
1/2 second to exit to normal operation.
11. Press and hold in the
[
BAND
(
SET
)]
key for 1/2 second
to enter the Set mode again, then rotate the DIAL knob
to select Menu #7 (
CWIDCWID
CWIDCWID
CWID).
12. Press the
[
BAND
(
SET
)]
key momentarily, then rotate
the DIAL knob to select “
TX ONTX ON
TX ONTX ON
TX ON” (to enable the CW
identifier).
13. Press the
[
BAND
(
SET
)]
key momentarily to save the new setting, then press and hold in
the
[
BAND
(
SET
)]
key for 1/2 second to exit to normal operation.
ARTS
™
: AUTO RANGE TRANSPONDER SYSTEM