Operation Manual
52
Menu Operation
The Menu System allows you to customize a wide variety of transceiver performance
aspects and operating characteristics. Once you have gone through the various Menu
customization procedures initially, you will nd that you will not have to resort to them fre-
quently during everyday operation.
Menu Operation
1. Press and hold in the key for one second. The Menu Item number and a brief title
for the Menu Item will appear in the display.
2. Rotate the
knob to select the Menu Item you wish to work on.
3. When you have chosen the desired Menu Item
number, rotate the
knob to change the
value or condition for the Menu Item.
4. When you have made your selection, press and
hold in the
key for one second to save the
new setting and exit to the normal operation.
In step (3) above, if you press the
key
momentarily, it will reset the setting of thatMenu Item to its factory-default value.
In step (4) above, if you press the
key momantarily, you will exit to normal
operation without saving the new setting.
Menu Item Function Available Values Default
01 144 ARS
Activate/deactivate the Automatic Repeater Shift
when operating on the 144 MHz band
OFF/ON
1
02 430 ARS
Activate/deactivate the Automatic Repeater Shift
when operating on the 430 MHz band
OFF/ON
1
03 9600 MIC
Adjust the audio input level from the TNC
during 9600 bps Packet operation
0 ~ 100 50
04 AM&FM DL
Enabling/disabling the
knob on the AM and FM
modes
ENABLE/DISABLE DISABLE
05 AM MIC Adjust the microphone gain level for the AM mode 0 ~ 100 50
06 AM STEP
Select the tuning steps for the
knob on the AM
mode
2.5/5/9/10/12.5/25kHz
1
07 ANTENNA
Select the antenna connector to be used on each oper-
ating band (HF/50/144/430 MHz)
FRONT/REAR
1
08 APO TIME
Select the Auto Power Off time (time before power goes
off)
OFF/1h ~ 6h OFF
09 ARTS BEEP Select the ARTS beep mode OFF/RANGE/ALL RANGE
10 BACKLIGHT Select the LCD lamp mode OFF/ON/AUTO AUTO
11 BATT-CHG Select the battery charging time 6/8/10 h (hours) 10
12 BEEP FREQ Select the beep frequency 440/880 Hz 880 Hz
13 BEEP VOL Select the beep volume 0 ~ 100 50
14 CAT RATE Set the transceiver’s circuitry for the CAT baud rate 4800/9600/38400 bps 4800 bps
15 COLOR Select the illumination color for the LCD illumination
COLOR1 (Blue)/
COLOR2 (Amber)/
COLOR3 (Violet)
COLOR1
16 CONTRAST Setting of the display contrast level 1 ~ 12 5
17 CW DELAY
Set the receiver recovery time during pseudo-VOX CW
semi-break-in operation
10 ~ 500 msec 250 msec
18 CW ID
Enables/disables the CW identifier during ARTS
operation
OFF/ON OFF
19 CW PADDLE Select the keyer paddle’s wiring conguration NORMAL/REVERSE NORMAL
CLAR
E
L
S
A B
C
F
V
LOCK
PWR
SQL/RF
A
F
HOME
M
SEL
F
DIAL
HOME
C