Operation Manual
58
Menu Operation
Menu Item 27 [DIG SHIFT]
Function: Dene the carrier frequency offset during DIG (USER-L or USER-U) mode op-
eration.
Available Values: –3000 ~ +3000 Hz
Default: 0 Hz
Menu Item 28 [EMERGENCY]: USA Version only
Function: Enable Tx/Rx operation on the Alaska Emergency Channel, 5167.5 kHz.
Available Values: OFF/ON
Default: OFF
When this Menu Item is set to “ON,” the spot frequency of 5167.5 kHz will be enabled. To
get to this frequency, use the
knob to navigate; the Alaska Emergency Channel will
be found between the Memory channel “M-PU” and “M-001”.
Use of this frequency is restricted to amateurs operating in (or within 92.6 km of)
the U.S. State of Alaska, and it is to be used for emergency communications only
(involving the immediate protection of life or property).
Menu Item 29 [FM MIC]
Function: Adjust the microphone gain level for the FM mode.
Available Values: 0 ~ 100
Default: 50
Menu Item 30 [FM STEP]
Function: Select the tuning steps for the
knob on the FM mode.
Available Values: 5/6.25/10/12.5/15/20/25/50 kHz
Default: 5 kHz (depends on operating band and transceiver version)
Menu Item 31 [ID]
Function: Store your callsign into the CW identier. Up to eight characters may be stored.
The storage procedure is as follows:
1. Press the
knob momentarily to initiate callsign storage (an “under-bar” will
appear below the rst character location of the callsign).
2. Rotate the
knob to select the rst letter/number of your callsign, then rotate
the
knob one click clockwise to save the rst letter/number and move to the
next entry position.
3. Repeat the previous step as many times as necessary to complete your callsign.
4. Press the
knob to save your completed callsign and exit.
Default: YAESU