Operation Manual

VX-7R OPERATING MANUAL62

AUTOMATIC LAMP ILLUMINATION ON SCAN STOP

The VX-7R will automatically illuminate the LCD Lamp whenever the scanner stops on

a signal; this allows you to see the frequency of the incoming signal better at night. Note

that this will, of course, increase the battery consumption, so be sure to switch it off

during the day (the default condition for this feature is “ON”).

The procedure for disabling the Scan Lamp is:

1. Press the key, then press the key to enter the Set mode.

2. Rotate the DIAL to select the Menu Item labeled (

ScanScan

Scan

Modes #4: SCAN LAMPModes #4: SCAN LAMP

Modes #4: SCAN LAMP).

3. Press the or key to set this Menu Item to

OFFOFF

OFF.

4. When you have made your selection, press the PTT to

save the new setting and exit to normal operation.

BAND EDGE BEEPER

The VX-7R will automatically “beep” when a band edge is encountered during scanning

(either in standard VFO scanning or during PMS operation). You may enable this feater

(band edge beeper) when the frequency reaches the band edge while selecting the VFO

frequency by the DIAL.

The procedure for enabling the Band-Edge Beeper is:

1. Press the key, then press the key to enter the Set mode.

2. Rotate the DIAL to select the Menu Item labeled (

ScanScan

Scan

Modes #2: EDGE BEEPModes #2: EDGE BEEP

Modes #2: EDGE BEEP).

3. Press the or key to set this Menu Item to

ONON

ON.

4. When you have made your selection, press the PTT to

save the new setting and exit to normal operation.

SCANNING