Operation Manual
VX-7R OPERATING MANUAL70
Selecting the Wave-Form Display
1. Press the   key, then press the   key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (
Mea-Mea-
Mea-Mea-
Mea-
surements #2: WAVE MONITORsurements #2: WAVE MONITOR
surements #2: WAVE MONITORsurements #2: WAVE MONITOR
surements #2: WAVE MONITOR).
3. Press the   or   key to select the desired wave form
(
RX SIGNALRX SIGNAL
RX SIGNALRX SIGNAL
RX SIGNAL, 
TX MODULATIONTX MODULATION
TX MODULATIONTX MODULATION
TX MODULATION, or 
AllAll
AllAll
All).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Selecting the Units of Temperature Display
1. Press the   key, then press the   key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (
Mea-Mea-
Mea-Mea-
Mea-
surements #3: TEMP UNITsurements #3: TEMP UNIT
surements #3: TEMP UNITsurements #3: TEMP UNIT
surements #3: TEMP UNIT).
3. Press the   or   key to select the preferred unit (
°C°C
°C°C
°C
or 
°F°F
°F°F
°F).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Selecting the Unit of Atmospheric Pressure Meter (Barometer)
1. Press the   key, then press the   key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (
Mea-Mea-
Mea-Mea-
Mea-
surements #4: BARO UNITsurements #4: BARO UNIT
surements #4: BARO UNITsurements #4: BARO UNIT
surements #4: BARO UNIT).
3. Press the   or   key to select the preferred unit (
hpahpa
hpahpa
hpa/
mbarmbar
mbarmbar
mbar/
mmHgmmHg
mmHgmmHg
mmHg/
inchinch
inchinch
inch).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Correcting the Atmospheric Pressure Meter (Barometer Offset)
1. Press the   key, then press the   key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (
Measurements #5: BARO OFF-Measurements #5: BARO OFF-
Measurements #5: BARO OFF-Measurements #5: BARO OFF-
Measurements #5: BARO OFF-
SETSET
SETSET
SET).
3. Press the   key to enable setting of this Menu Item.
4. Press the   key to indicate the barometer data in “hpa”
units.
5. Press the   or   key to adjust the VX-7R display to the calibrated barometer
value in the “hpa” units.
6. Press the   key to save the new setting.
7. Press the PTT key momentarily to exit to normal operation.
SENSOR MODE
SENSOR MODE OPTIONS










