User manual

6-2 Laser Aiming Device (LAD™) Operation Studio Spot
®
250 / Studio Color
®
250 User Manual
6. Do not remove the labels shown in Figure 6-1. These
labels are required by US and European safety agencies.
7. Post a standard laser warning sign to mark areas where
this product is used.
8. Do not stare directly into the beam and do not view the
beam with optical instruments.
9. Always position the laser path well above or below eye
level.
10. Terminate the laser beam at the end of its useful path.
11. Consult local and state laws regarding laser use and
possible registration requirements.
Overview of Operation
The Studio Spot 250 and Studio Color 250 LAD allows you to position the light beam
during daylight or high ambient light conditions. With this additional flexibility, you
can set up or verify the fixture’s pan/tilt positions in conditions that would otherwise
make beam positioning difficult or impossible.
Figure 6-1. LAD™ labels on the fixture.
Top view of fixture
Fixture with bezel removed