User manual

6-6 Laser Aiming Device (LAD™) Operation Studio Spot
®
250 / Studio Color
®
250 User Manual
7. Once you have marked the ideal laser position, turn the lamp off and set the
LAD continuously on (see
“Choosing a Macro (MACR)” on page 5-8, and
choose the “LRON” menu option).
8. Look at the wall where the laser is projected to determine the current laser
position in relation to the mark you made on the wall for the ideal laser
position.
Caution: Do not stare into the laser beam or view it directly with
optical instruments.
Figure 6-6. Locate the center of the beam on the wall and mark the ideal laser position.
Extend the tape measure or ruler
through the vertical center of the beam.
1
2
Lightly mark the center of the beam
on the wall along the ruler.
3
4
Extend the tape measure or ruler
across the horizontal center of the
beam and lightly mark the center of
the beam on the wall along the ruler.
Measure 3.3 in (8.4 cm) for Studio Spot 250
fixtures, or 3.5 in. (8.9 cm) for Studio Color
250 fixtures above the center point of the
marks you made on the wall to mark where
the laser should shine.