User manual

7-8 General Maintenance Studio Spot
®
250 / Studio Color
®
250 User Manual
2. Locate the cutout on the mid plate under the color wheel (see Figure 7-9).
Manually rotate the color wheel until the dichroic you wish to replace is
directly over the cutout.
3. Place your finger through the cutout and push the dichroic you wish to replace
toward the center of the wheel (and under the retaining clip) to free it from
the two wheel tabs as shown in
Figure 7-10.
4. Once the dichroic is free of the two wheel tabs, angle the free end up and pull
the dichroic out of the wheel.
Figure 7-9. Cutout on the mid plate under the color wheel.
front plate
mid plate
Litho wheel
Color wheel
Effect wheel
cutout to access
color wheel
Figure 7-10. Free the dichroic by pushing it toward the retaining