User manual

Studio Spot
®
250 / Studio Color
®
250 User Manual page xiii
Figure 6-4. Orient the fixture for laser alignment. .....................................................6-4
Figure 6-5. Remove the bezel. ...................................................................................6-5
Figure 6-6. Locate the center of the beam on the wall and mark the ideal laser
position. ....................................................................................................6-6
Figure 6-7. LAD™ mounting/alignment screws. ........................................................6-7
Figure 7-1. Remove the two panel covers. ................................................................7-2
Figure 7-2. Loosen the two display panel retaining screws. .....................................7-3
Figure 7-3. Lower the display panel. .........................................................................7-3
Figure 7-4. Fuses on the circuit board. ......................................................................7-3
Figure 7-5. Lamp cap and lamp assembly screws. ....................................................7-5
Figure 7-6. Remove the lamp assembly. ....................................................................7-5
Figure 7-7. Remove the lamp from the lamp socket. ................................................7-6
Figure 7-8. Remove the fixture’s bezel. .....................................................................7-7
Figure 7-9. Cutout on the mid plate under the color wheel. ....................................7-8
Figure 7-10. Free the dichroic by pushing it toward the retaining clip. ...................7-8
Figure 7-11. Determining the coated side of dichroic glass. .....................................7-9
Figure 7-12. Location of the spring and built-in plastic tab on the wheel housing. .7-9
Figure 7-13. Rotating litho and aperture ring. .........................................................7-10
Figure 7-14. Removing a static litho. .......................................................................7-10
Figure 7-15. Replacing a static litho. ........................................................................7-11
Figure 7-16. Replacing the spring on a rotating litho or effect. .............................7-12
Figure 7-17. Remove the fixture’s bezel. .................................................................7-13
Figure 7-18. Location of the C-clips, lens shafts, focus screw, and lens assembly. .7-14
Figure 7-19. Location of the eight screws on the optical assembly front plate. .....7-14
Figure 7-20. Optical assembly cover plate folded toward the sensor bracket. ......7-15
Figure 7-21. The three lens screws. .........................................................................7-17
Figure 7-22. Remove the screws that secure the lens to the lens assembly. ..........7-18
Figure 7-23. Orient the fixture for lamp optimization. ............................................7-19
Figure 7-24. Lamp optimization screws. ..................................................................7-20
List of Tables
Table intro-1. Studio Spot
®
250 and Studio Color
®
250 Optional Accessories .intro-8
Table 2-1. Example: Determining the DMX Start Channel ..................................... 2-4
Table 2-2. Example: Determining the Unique Fixture Number ...............................2-5
Table 2-3. Example of Wasted DMX Channels ..........................................................2-6
Table 3-1. Fixture Constructs and Channel Assignments ......................................... 3-2
Table 3-2. Color Function Settings ............................................................................3-4
Table 3-3. Cyan Settings .............................................................................................3-5
Table 3-4. Magenta Settings .......................................................................................3-5
Table 3-5. Yellow Settings ..........................................................................................3-6