User manual

Studio Spot

250 / Studio Color

250 User Manual General Maintenance 7-13

9. Install the metal spring by inserting the spring into the wheel housing (over the

effect) and rotating the spring while pressing down.

When the spring is completely installed in the wheel, press the spring tip under

one of the four plastic tabs in the wheel housing (see

Figure 7-16).

10. After replacing an effect, you may need to clean it by using a soft, lint-free

cotton cloth and a mild glass cleaning solution (containing no ammonia).

11. Replace the bezel and engage the two bezel latches unless there are other

dichroics, lithos, or effects you want to replace.

Replacing a Studio Color

250 Wheel

This section shows how to replace the cyan, magenta, yellow, or beam shaping

(lenticular) wheel. You should replace the wheels if they are damaged or broken.

(See

“Optional Accessories” on page intro-8 for ordering information.)

Warnings: Disconnect power before servicing.

Equipment surfaces may reach temperatures up to 130° C

(266° F). Allow the fixture to cool before handling.

You will need:

•C-clip tool

• #2 Phillips-head screwdriver

• 5/64 in. hex tool

• replacement wheel

To replace a Studio Color 250 wheel:

1. Remove the fixture’s bezel by releasing the two bezel latches (see Figure 7-17).

Figure 7-17. Remove the fixture’s bezel.

release the

two bezel

latches

fixture with bezel removed