User manual

Studio Spot
®
250 / Studio Color
®
250 User Manual Troubleshooting 8-1
8
Chapter 8
Troubleshooting
This chapter lists typical symptoms and solutions for problems you might experience
when using your Studio Spot 250 or Studio Color 250 fixture. If you need additional
help, or if the problem you are experiencing is not listed in this chapter, contact High
End Systems customer service in one of the ways shown in the section titled
“Contacting High End Systems” on page ii.
Caution: This fixture must be serviced by qualified personnel. The
information listed in this section is intended to assist qualified
personnel only.
LED Display Error Messages
The Studio Spot 250 or Studio Color 250 menu system provides a comprehensive
listing of error messages when problems occur. If the solution listed in
Table 8-1 does
not solve the problem, contact High End Systems customer service (see “Contacting
High End Systems” on page ii).
Table 8-1. LED Error Messages
Display
Message
Problem Solution
ADDR
LOST
The fixture was unable to
retrieve the unique DMX start
channel / fixture address. This
error message may be
received if you change the
fixture type (SPOT or COLR)
and cause the fixture’s DMX
channel range to overlap
another fixture’s channel
range.
Set the starting channel / fixture number again (see
“Address Menu (ADDR)” on page 4-20) or contact High
End Systems customer service (see “Contacting High
End Systems” on page ii).
ADDR
OVER
A new logic board (without a
stored address) was installed
in the fixture or the memory
location has not been
initialized.
Verify the starting channel or fixture number (see
“Assigning a Fixture Address” on page 2-3).