User manual

1-4 Setup and Installation Studio Spot

250 / Studio Color

250 User Manual

4. Gently lower the display panel to access the voltage switch blocks on the circuit

board (see

Figure 1-4).

5. Locate the voltage select label (see Figure 1-4) and the three switch blocks labeled

“SW1,” “SW2,” and “SW3” on the circuit board located on the inside of the

display panel (see

Figure 1-5).

6. Choose an input voltage/frequency for the fixture by setting the switches as shown

on the voltage select label (see

Figure 1-6).

For example, to set the voltage input to 120 volts, 60 hertz, set switch 3 up ( ),

switch 2 down ( ), and switch 1 down ( ).

7. After selecting an input voltage/frequency, return the display panel to its original

position and tighten the two display panel retaining screws.

8. Replace the two panel covers and tighten the four cover retaining screws.

Figure 1-4. Lower the display panel.

gently lower the

display panel

voltage

select

label

SW1 SW2 SW3

6.3 A 25 0V SLOW

2.5 A 25 0V FAS T

6.3 A 25 0V FAS T

SAME TYPE AND RATING

RE PL ACE FUSE S WI TH CAUTION :

SW1

SW2

SW3

Figure 1-5. Circuit board containing the three switch blocks.

Figure 1-6. Voltage select label.